Biomaterials with the hydroxyapatite and biopolymers such as chitosan derived of crustaceans are is an alternative for bone repair. Carbon nanotubes have been a focus of interest because they can ameliorate the biomechanical properties of biomaterials. The objective of this study was to evaluate these materials in the repair of cranial defects in rats. The animals were divided in groups: without implant (G1), implanted with the chitosan/carbon nanotube membrane (G2), and chitosan/nanotube membrane mineralized with hydroxyapatite (G3). The animals were sacrificed 5 weeks after surgery and the skulls were removed for analysis of the defect area. The results showed absence of chronic inflammatory and little bone neoformation in the defect area of all groups. In G2 and G3 there was lack of reabsorption of the biomaterial that were encapsulated by connective tissue. In conclusion, the biomaterials were biocompatible, but their specific physicochemical properties did not indicate a considerable osteoregenerative capacity.

Biomaterials are used as a promising alternative to bone grafts, including bioceramics whose composition resembles that of bone and fibrin sealants due to their hemostatic properties. The objective was to evaluate the repair of cranial defects in 40 rats, grafted with hydroxyapatite and a new fibrin sealant derived from snake venom. The animals were divided into four groups: C (control, no graft); Ha (hydroxyapatite); FS (fibrin sealant), and HaFS (hydroxyapatite and fibrin sealant). The animals were euthanized 2 and 6 weeks after surgery and wound area were submitted to analysis. After 2 weeks, immature bone was formed from the borders of the defect and in groups Ha and HaFS, few hydroxyapatite particles were surrounded by new bone. After 6 weeks, the new bone was mature and surrounded several hydroxyapatite particles, without connective tissue interposition and the volume of new bone was higher in HaFS group. The hydroxyapatite in combination with the new fibrin sealant accelerates bone repair.

The effect of different propionaldehyde ratios on the properties of bis-GMA-based comonomers and copolymers diluted with propoxylated bis-GMA (CH3bis-GMA) was evaluated. Five experimental comonomers were prepared combining bis-GMA with CH3bis-GMA and propionaldehyde at 0, 2, 8, 16, 24 mol%. Light polymerization was effected with the use of 0.2 wt. (%) each of camphorquinone and N,N-dimethyl-p-toluidine. Resin degrees of conversion (%DC) were evaluated by FT-IR spectrophotometry and Tg by Differential Scanning Calorimeter. Complex viscosity (η*), the effect of temperature on η*, and Microhardness (H) for dry and wet samples were also determined. Data were analyzed by Student's t-test, one-way ANOVA and Tukey-Kramer test (α = 0.05). The group with 24 mol% additive had a significant increase in %DC and H, and the lowest comonomer Tg and η*. No remarkable variation was noted in copolymers Tg s. All resins presented Newtonian behavior of viscosity, which linearly decreased with increased temperature. The η* decreased sigmoidally as the additive ratio increased.